© LAP3 USA
E-mail Support: Sales@lap3usa.com
Tel: 703-774-7341
Mar 27

Turbo upgrade

0 comments

Can you tell me more about the upgrade your working on? I seen a picture with a bigger turbo and piping but can't find it. What hp is it producing?

New Posts
  • Tools Needed - Large Zip Ties - 8-10mm Sockets - Electrical Tape - Velcro Tape - Android device with Google Play Store access. Installation Time: ~15-30min depending on experience. Step 1: Disconnect the battery Step 2: Locate the section of cable labeled "MAP" from the ProTuner main harness. Disconnect the factory MAP sensor plug, and connect the Pro-Tuner MAP sensor cable. Step 3: Locate the section of cable labeled "BOOST" from the ProTuner main harness. Disconnect the factory BOOST sensor plug, and connect the Pro-Tuner BOOST sensor cable on each end of the factory cable. *Note: The BOOST map sensor is located on the pipe before the throttle body, and it looks just like the Map sensor you connected on the Step 2. . Note: The BOOST sensor is located on the cold pipe just before the throttle body Step4: Locate the CRANK sensor underneath the factory charge pipe. Find the Y-cable labeled as "CRANK" from the Pro-Tuner box. Disconnect the factory CRANK sensor cable, and connect the Pro-Tuner CRANK sensor cable on each end of the factory plugs. Locate the matching plug from the Pro-Tuner main harness and connect the other end of the crank cable. Step 5: Locate the CANbus cable from the Pro-Tuner and connect it to the CANbus port located next to the engine by the passenger side. Use electrical tapes to secure the connection. Step 6: Locate the Bluetooth Module from the Pro-Tuner box, and connect it to the matching plug on the Pro-Tuner harness. Step 7: Optional Speed Limiter Canceler(Green Wires) - Coming Soon Step 8: Use electrical tapes on each end of the Blue & Green wires as they are not used. Step 9: Locate and connect the power wire from the Pro-Tuner to terminal location inside the fuse box. Step 10: Connect the Battery Step 11: Grab your Android device, install PROSS app from Google Play store. (Link: LAP3 V2 PRO-TUNER PROSS BT APP ) Start the car and pair the device through the phone Bluetooth Setting. When you open the app, it will ask you for serial#. The Serial number is located behind the Bluetooth module. Once its up and running, confirm the 3 indicators (Bluetooth,OBD2,Uncle Chip) on the app are RED. Step 12: Select the ECU CONTROL MODE button and to choose your mode. Mode 1 - Stock Map Mode 2 -93 Octane Mapping Mode 3 - E30 Mapping (Requires 4-5 gallons of E85 and topped off with 91-93 octane) Meth Mode - Meth Injection Mapping (Requires 70%+ Meth mix, 500mm Injection starting @ 5psi & Max Spray @ 15psi) User Map - 91 Octane Mapping unless the user customizes the map through the app Step 13: Enjoy!
  • Everone is pushing the V6 and i know there potential for thia motor (or aleast hope).