Please do not use this feature unless you are comfortable with self-tuning. You must know how to read logs, and know that you are responsible for changes you make. User Mapping Data Adjustment
Step 1. Get the app connected to the Pro-Tuner. Go to the Setting and select "User Adjustment"
Step 2. Press "READ" to load the current User Map. If it loads data successfully, programmed 91 octane tune data will appear.
If the app does not load any data and everything stays 0%, please do not proceed. Once the data loads, utilize the loaded 91 Octane mapping as a baseline. If you accidentally pressed "SEND" without loading the data first causing to wipe the data, please contact us for values. Step 3. Adjust Boost, Fuel Bias(Higher % = Leaner AFR), and Methanol Pump Duty by 1-2% at a time, and press SEND. It may take up to 30sec to send & save the data. It will overwrite all previous data. Boost values only affect the User Mode; however, Fuel Bias & Methanol Pump Duty values will affect all modes(2, 3, Meth, User Mode)
Utilize the data logging system to monitor changes, and repeat the process if you wish to make more adjustments.
Fail Safe Using the metric system, you can set up safe guard to limit the boost pressure.
Input 1.00 bar(Pressure at Sea Level) + Desired Boost value of X.XX Bar.
For example, if you want the vehicle to go into safe mode at 1.5 bar(21.7PSI), simply add 1.00+1.50 and input 2.50 bar. Speed Control
If your speed wires are installed, you can turn them on or off via Pro-Tuner app. IAT(Intake Air Temperature) Control You can turn them on to fool the IAT sensor to reduce timing being pulled from high IAT values. Knock Detection
It will remain "OFF," until it detects Knock. If it detects knock, it will show "ON"